BULL BAR
1998-2011 FORD RANGER
Page 2 of 4 12/2/2011REV1(DP)
a long reach deep socket. Snug but do not tighten hardware at this time. Repeat this Step for
passenger side Frame Mounting bracket installation. IMPORTANT! Do not over-tighten the
Mounting Bracket hardware or damage to the frame may result.
3. Next, determine the correct mounting position for the driver side Bull Bar Mounting Bracket:
a. 98-09 models: Use the higher installed position to raise the Bull Bar, (See Figure 6A).
b. 2010-11 models: Use the lower installed position to clear the factory spoiler, (See Figure 6B).
4. Bolt the driver side Mounting Bracket to the outside of the Frame Mounting Bracket with the included
(2) 10mm x 35mm Hex Bolts, (4) 10mm Flat Washers, (2) 10mm Lock Washers and (2) 10mm Hex
Nuts, (Figure 6A or 6B). Do not tighten hardware at this time. Repeat this Step for passenger side
Bracket installation.
5. With help position the Bull Bar up to the Mounting Brackets. Use the included (2) 12mm x 50mm Hex
Bolts, (2) 12mm Lock Washers and (2) 12mm Flat Washers to attach the Bull Bar to the Mounting
Brackets, (Figure 7). Snug but do not tighten hardware at this time.
6. Adjust the Bull Bar properly and tighten all hardware. IMPORTANT! Do not over-tighten the Mounting
Bracket hardware or damage to the frame may result.
7. On vehicles with plastic airbox removed in Step 1: Remove the (2) plastic clips from the plastic air
box, (Figure 8). Hold the airbox up to the vehicle. Insert the plastic clips into the forward previously
unused holes if there are corresponding holes in the bottom of the frame. If there are no holes in the
frame, discard the plastic clips. Place the air box in position over the 8mm Double Sided Stud on the
driver side. Secure the air box to the 8mm Double Sided Stud with (1) 8mm Flat Washer, (1) 8mm Lock
Washer and (1) 8mm Hex Nut, (Figure 9). Bolt the front of the airbox to the frame rail with the factory
hex bolt and the plastic clip-if used, (Figure 10). Do not tighten hardware at this time. Repeat this step
to attach the air box on the passenger side. Tighten all hardware.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Driver Side Installation Pictured
(Fig 1) Driver side mounting location pictured
(Fig 2) 2010-2011 model pictured
12mm x 110mm Hex Bolt
12mm x 32mm STD Flat Washer
Remove the factory plastic air box-if equipped
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals